Q & A details -I weld a lot of aluminum castings. Most of the time they weld fine, but sometimes the weld blows out at me. What’s going on?
Your current position: Tech Community > Answer > Q & A details
0861803284

I weld a lot of aluminum castings. Most of the time they weld fine, but sometimes the weld blows out at me. What’s going on?

1 answer Reward0 Remaining Time 0 Day

I weld a lot of aluminum castings. Most of the time they weld fine, but sometimes the weld blows out at me. What’s going on?

Other answers

  • 0861788249

    0861788249 2017-02-24 09:45:02

    The problem is caused by the casting process. There are three types of casting processes—sand casting, permanent mold casting, and die casting. The molds for sand casting and permanent mold casting are made from materials that conduct heat relatively poorly. Therefore, the molten casting material cools slowly within the mold, and any gases dissolved in the molten aluminum have a tendency to escape from the casting before it solidifies. Sand and permanent mold castings usually do not exhibit the problem you are seeing because the gas content of the solid casting is low. In die casting the mold is made from a water-cooled steel block. The molten aluminum is forced quickly into the mold and it, in turn, quickly solidifies. Die casting molds are expensive, so you won’t typically see them used in low-volume applications. In high-volume applications like outboard motor casings, lawn mowers, small power tools, and larger automotive castings, the cost of the molds is distributed over a very large quantity, making the die casting a quick and cheap way to go. The problem with die castings is that the molten aluminum cools before dissolved gases have a chance to escape, which means they are not distributed evenly. The gas then forms small pockets within the casting. Where they form depends on many factors, the most important has to do with the specifics of the mold design as well as the cooling channels. Most of the time you will have no difficulty welding on a die casting. However, if you are unlucky enough to try to weld over a gas pocket, the gas will expand because of the heat, causing the weld to blow out at you. Besides grinding out the bad weld and repair welding, there isn’t much else you can do. Usually by the second or third repair cycle the gas will be gone, making the weld acceptable. So how do you know if you are welding on a die casting? Look at both of the casting surfaces. If it’s a die casting, one surface will have a half dozen or so small, round marks that are 1/8 in. to 1/4 in. in size. They are readily visible and are caused by the ejector pins that push the casting out of the die.

    [ More ] [ Close ]
    reply
    Answer0861788249:
    Answer
More

Wococarbide

Member login

shuriyouwu
Forgot password?

Join free

Reset Your Password

Email:

SMS code:

Send Code

New Password:

Submit