working safety with glass

       

INSERTING GLASS TUBING INTO STOPPERS

 

1.     Wear eye protection and gloves (leather or thick rubber).

2.     The hole in the stopper should be only slightly smaller than the tubing.

1. Be sure the ends of the tubing are fire-polished (unpolished tubing is almost impossible to insert into a stopper without requiring a dangerously high amount of force).
2. Lubricate the hole and the end of the glass tubing. Good lubricants include glycerin, water, soap, stopcock grease, or soapy water. Use only a little, and choose a lubricant which will not react with any of the chemicals you plan on using with the apparatus.
3. Keep hand on tubing close to the stopper and out of line with the end of the tube.  Do NOT use your palm.
4. DO NOT FORCE THE TUBING. If you cannot easily get the tubing through the stopper, change lubricants or make the hole bigger.
5. Rotate the tubing as you insert it slowly. Add extra lubricant as needed.
6. Do not rock the tubing back and forth. This can easily shatter the tubing.
7. When stoppers and glass tubing become sealed together, they must not be separated by force. Either cut the stopper loose or discard the equipment.

CUTTING A GLASS ROD OR TUBING

1.     Always wear eye protection!

2.     Score the glass only once, firmly. Multiple score lines will usually result in jagged breaks, or cause the end to shatter while snapping it.

3.     Use the correct tool for scoring. A hardened triangular file, or a special tungsten carbide or diamond-edged scoring blade will work. Glass is very hard, and will only snap cleanly with a sharp score line.

4.     Never hold the glass with bare hands while snapping it. Use heavy gloves if available, and wrap the glass in a cloth. The cloth will serve to catch the slivers which invariably are produced during snapping.

5.     Anything with a diameter greater than 10 mm should be cut with a glass saw.

6.     Fire polish the ends.

 

 

 

MISCELLANEOUS

1. Glass gets EXTREMELY HOT, and you can't tell how hot it is by looking at it.  So use hot pads, insulated hot mitts or gloves.  Leave a warning note for others in the area.
2. Don't lay hot glass on cold surfaces or in water. It will crack easily, wasting your work and possibly hurting someone.
3. Keep glass moving and rotating in a flame. Don't let the flame sit on one spot for more than a moment. Glass can shatter if it is heated unevenly.
4. Eye protection should be worn when working with glassware.

DISPOSAL

1. Inspect before use and discard broken, chipped or cracked glassware.
2. Never handle broken glass with your bare hands.  Use a brush and dustpan to clean up broken glass immediately.  Forceps or tape can be used to pick up smaller pieces.
3. Dispose of all uncontaminated glassware (non-hazardous, non-pathological, non-radioactive) in the appropriate manner (NOT in the black garbage bags).