What are the commonly used repair types for thermal spraying

       Flame spraying, oxyethylene flame powder spraying, oxyethylene flame wire spraying, oxyethylene flame spray welding, high speed flame spraying (HOVF), arc spraying, plasma spraying, atmospheric plasma spraying, low pressure plasma spraying







 1. All kinds of cement machinery shafts, holes, planes, and special-shaped surfaces can be repaired mechanically or on site!







For example: various types of crusher main shaft bearing positions; movable jaw bearing holes; various conveying fan main shafts (such as Roots blowers); various motor rotor bearing positions; mills, reducer gear shaft bearing positions;







The surface treatment and repair of the roller surface of the roller reamer, the tower base, the partition board, the lining board, the enhanced life, etc., many wear and tear can be repaired on site!







All kinds of cement machinery shafts, holes, planes, and special-shaped surfaces can be repaired mechanically or on site!







2. All kinds of mold damages, strains, corners, bumps, pits, etc. that lead to mold failure can be repaired and repaired on site!







After the repair, the mold will not be annealed, undercut, or deformed. The bonding strength is metallurgical bonding except for brush plating, which is ionic bond bonding. The bonding strength is comparable to that of the matrix. After the repair, the material and hardness can be selected according to the mold matrix!







Plastic injection molds, zinc-based alloy plastic molds, TV shell molds, tire molds, various injection mold cavities, telephone mold bases, table tennis molds, telescope molds, water meter molds, plastic buckets, plastic cups and other plastic products molds , Glass molds, cold stamping dies