Angle grinder operation and maintenance procedures

       The correct operation and use of the angle grinder can ensure production safety. The following wococarbide.com editor will first introduce the operation and maintenance procedures of the angle grinder:



【Operation procedure of angle grinder】



Before using the angle grinder, wear protective goggles, wear appropriate work clothes, do not wear loose work clothes, do not wear jewelry or have long hair, and are strictly prohibited from wearing gloves and unbuttoned cuffs.



After turning on the switch, wait for the grinding wheel to rotate stably before it can work.



The cutting direction cannot be towards people.



After working continuously for half an hour, stop for 15 minutes and wait for it to dissipate heat before using it. After prolonged use, the machine should run at no-load speed for a short period of time to cool the motor.



When cutting or grinding with an angle grinder, hold the handle of the angle grinder firmly and apply force evenly.



It is not possible to hold small parts by hand to process the angle grinder.



If there is abnormal sound, or excessive vibration or leakage, the inspection should be stopped immediately; the power must be cut off before repairing or replacing accessories, and the saw blade should stop immediately.



When using the cutting machine, such as working in a wet place, it must be carried out on an insulating mat or a dry wooden board. Safety precautions must be taken when climbing up or using it in hazardous areas such as explosion-proof.



After completing the work, consciously clean the work environment.



Before use, be sure to check whether the angle grinder has a protective cover, whether the protective cover is stable, and the grinding disc of the angle grinder is installed firmly.



It is strictly forbidden to use the broken grinding wheel. When cutting, you should prevent sparks from splashing around, avoid splashing on others, and keep away from flammable and explosive items.



When the angle grinder is first opened, there will be a large swing, so it is necessary to hold it firmly.



【Daily maintenance of angle grinder】



The slide and rotating parts of the machine should be lubricated and maintained at intervals of one month.



After use, the countertop should be cleaned and the equipment should be wiped clean.



The carbon brushes of the angle grinder are consumables and should be replaced after a period of use. Make sure that it is in good contact when replacing.