What are the types of repairs commonly used in thermal spraying?

       

Thermal spraying manufacturers include flame spraying, oxy-ethyl flame powder spraying, oxy-ethyl flame wire spraying, oxy-ethyl flame spray welding, high-speed flame spraying (HOVF), arc spraying, plasma spraying, gas plasma spraying, low pressure plasma spraying.

1. The wear of various cement machinery shafts, holes, planes, and special-shaped surfaces, the failure of matching positions, the wear of bearing positions, sealing positions, and bearing pad positions can be mechanically repaired or repaired on site!



Such as: various types of crusher main shaft bearing positions; movable jaw bearing holes; various types of conveying fan main shafts; various motor rotor bearings; mill, reducer gear shaft bearing positions; , The surface treatment and repair of the scouring surface of the separator and the lining plate, such as strengthening and strengthening the life, can repair a lot of wear on site! The wear of various cement machinery shafts, holes, planes, and special-shaped surfaces, fitting position failures, bearing positions, sealing positions, and bearing shell positions can be mechanically repaired or repaired on site!



2. Damage, strain, slump, bumps, pits, etc. of various molds. Die failures can be repaired and repaired in the field!



After repair, the mold is not annealed, undercut, or deformed. Except for the brush plating, which is an ionic bond combination, the other bonding strengths are all metallurgical combinations comparable to those of the substrate. After repair, the material and hardness can be selected according to the mold base!



Plastic injection molds, zinc-based alloy plastic molds, TVs, tire molds, various injection mold cavities, telephone mold bases, table tennis molds, telescope molds, water meter molds, plastic buckets, plastic cups, etc.