What should we pay attention to when analyzing the actual operation of supersonic spraying?

       Only electromagnetic energy and air compression are used on site, and combustible gases such as CO2 and acetylene are not required. The system can be trusted. What should be paid attention to in the actual operation of supersonic spraying? The following supersonic spraying manufacturers will introduce you in detail!



The output power of the remelting gun should be sufficient, and one or two auxiliary guns can be equipped if necessary; neutral flame is selected, and the upper and lower spray distance is generally 40mm; the remelting temperature is about 1000°C. Be sure to handle it properly. If the temperature is too high, the molten layer will overflow and appear corrugated lines, reducing the flatness of the coating surface; but if the temperature is too low, the entire slag formation process cannot be carried out smoothly, and the strength of the spray welding layer is uneven and slightly lower. Reducing maintenance can improve the overall work efficiency, the work scope is large, and the upgrade probability is high; the production and manufacturing of various mixed production lines can be completed.

In the cannon, as two electrical transmission lines, the energy, temperature and advantages of sonic spray are constantly transferred to each other from the desired angle, with many benzene rings and other structures in the molecular formula, which consumes it due to its melting. Hypersonic spraying is a very suitable raw material for metal composites. Therefore, according to this, hypersonic spraying is also a surface solving technology. The above is the detailed introduction of ultrasonic spraying.

Because the particles have high mechanical energy to collide with conventional surfaces, the particles can produce high-quality HVOF processing without complete melting. This kind of water is not domestic water, and the temperature is 52~204oc (3). It is easy to operate and maintain. The figure shows an example of a first-order full-process projection obtained for different temperature and rate ranges for two different blended natural materials for HVOF spraying aluminum. Because the particles have high mechanical energy to collide with conventional surfaces, the particles can produce high-quality HVOF coatings without complete melting, preventing them from being unsuitable for use.



It is the key raw material for fireproof coating of water conservancy steel structure. After Z, according to the actual plan, they conduct manufacturing and equipment, conduct customer engineering acceptance, and select Laval nozzles for supersonic spraying to increase the speed of the cyclone from subsonic to supersonic, and improve the practicality of the cyclone for particle acceleration The effect, in addition, the particle velocity has been increased. This coating can be deposited over large or some very limited areas and has excellent dry-set properties and other properties.



It is widely used. Not only are such hearth rolls required to have high wear resistance and scratching properties, but also adhesion to iron or compounds must be removed. In this case, there is only a large number of various surfaces that can be used to enhance the technical performance, and sonic spraying can only solve this problem by improving the surface properties of the part